Da die Hall Ausgänge von meinem Motor mit dem Kelly-Controller verbunden sind, frage ich mich, ob es irgendeinen Ärger gibt, wenn ich von einem der Kabel (also dem gelben) das Signal Y-mässig abgreife. Nicht dass mir das Display den Hall-Sensor zerschiesst. Geht ja alles, der Motor dreht usw.in the back of lcd display , have "霍尔测速“ , it is connect to hall
don't connect blue or black wire , other colors is okay
( note : not control hall wire )
Note: This lcd display cannot be guaranteed to match with all electric vehicle motors hall.
, If the speed cannot be measured normally when connected, it can only be used to display the power and basic parameters|
Note: There are many exposed metal spots on the front and back of the display screen. You must think about it by yourself | Ways to make insulation and waterproof measures, otherwise it is easy to short-circuit and burn out accidentally
This lcd display cannot be guaranteed to match with all electric vehicle motors hall.
some electric vehicle motors hall can't compatible
was meinst Du?
grz
m