Elektroroller-Forum.de

Left Handle Switches

Deleted, see PDF file below.

Right Handle Switches

Deleted, see PDF file below.

All components of the main cable on one page. I hope nothing is missing.

Deleted, see PDF file below.

Electrical diagram of the Tromox Mino main cable.

vlad_vy hat geschrieben: Mi 7. Dez 2022, 18:22 Electrical diagram of the Tromox Mino main cable, draft version.
Tromox_Mino_main_cable.pdf

.
Danke für gute und übersichtliche Qualität.

Added some corrections to the electrical diagram of the Tromox Mino main cable. It looks like this is the final version.

It looks like OEM Lingbo LBMC 060122 HK3A EU M6 controller has not internal connection from the power terminal (+60V) to the pin 30, and pin 30 is powered from battery +60V over fuse 10A. So, if you use different LBMC controller, the +60V 10A fuse will be shorted and useless.

@vlad_vy
I am really fascinated how you have decoded all the wires and settings. Nevertheless do you see any chance to reprogamm the Lingbo Controller (60122)? There must be some way or equipement to do it? Where are the hidden settings and how can one get access?

I think it's almost impossible to reprogram an OEM 60122 controller. The only way is to read, decode, modify and flash the firmware again. But the firmware is protected from reading.

Main cable connectors Left & Right Handle switches

Unknown free connector (near to controller)

Unknown connector pinout (viewed from rear):
   _~~_
1| = = |2
   ~~~~
1) GND (12V, green); 2) +12V (yellow)